Kolorowy wyświetlacz dotykowy 10'': seria 1805 i 1886
Nowoczesna, cyfrowa technologia dla aplikacji z ograniczeniem prądowym 500 VA / 200 mA lub bezpieczeństwa.
Wysokiej klasy tester napięcia przepięciowego ze zintegrowanym pomiarem wyładowań niezupełnych.
Urządzenie Tester przeciwprzepięciowy ST 3820K udarowego z wbudowanym pomiarem wyładowań niezupełnych do zastosowań OEM w systemach.
Freely configurable for:
Customized for your DUT:
Surge voltage is a voltage pulse with which the test object is subjected to. A meaningful test is possible on stators, transformers and coils. A test on complete electric motors is only possible on pre-aligned permanent magnet motors, testing on squirrel cage motors is not useful.
With the surge voltage test the windings can be tested among each other and the windings against ground / housing. Insulation faults within the windings can also be detected. With a mere hipot test, the windings are tested against earth / housing, but not the windings among each other.
After connecting a charged capacitor with high voltage, the energy stored in the capacitor discharges into the inductance of the test object winding and back into the capacitor. This results in a sinusoidal curve, which is produced by the damped oscillation. Each inductance to be tested has a specific frequency and a characteristic amplitude curve.
The surge test is currently carried out on our products at a voltage of max. 6 kV. In practice, there are two methods of measurement: the master curve method and the double pulse method:
Used for 1-phase coils / windings. Two pulses are applied to the DUT one after the other and these are compared. Flashovers and insulation faults are detected by means of the two curves. Incorrect numbers of windings cannot be detected.
Recording of a master curve with a sample DUT. Incorrect numbers of windings are detected and a comparison of several windings (e.g. with a 3-phase DUT) is possible. Flashovers and insulation faults are detected by means of the curves.
The evaluation methods "Defect area", "Differential defect area" and "Tolerance band" are available. Evaluations are possible both with the "master curve method" and with the "double pulse comparison method".