Test cages
Test cage for the connection to standard testers
If, in accordance with EN 50 191, a test station with automatic protection against accidental contact has to be installed, a test fixture would be the perfect solution. The safety installation against indirect contact must guarantee that there are only voltages at the DUT when the enclosure lid is closed. A single fault must not prevent the disconnection at opening.
Special features
The cage is equipped with with one safety limit switch. The DUT is connected via 4 mm laboratory sockets, power outlet or multiple connectors according to DIN 41622. For upward swivelling of the acrylic glass hood, additional space is needed at the rear of the cage, exceeding the outer dimensions by 300 mm, with a max. swivelling angle of 75 degrees. The upward swivelling is supported by cylinders (air damping), i.e. secure stopping at upward position. The connection lines of the test cage are led out at the back. The built-in safety relay board offers protection from hardwarelike disconnection.
| Types | |
| HB 3300 | outside dimension: H=365 mm, b=540 mm, f=650 mm |
| inside dimension: H=330 mm, a=500 mm, c=390 mm | |
| HB 3400 | outside dimension: H=365 mm, b=590 mm, f=780 mm |
| inside dimension: H=330 mm, a=550 mm, c=510 mm | |
- conforms to CE, in accordance with EN 50 191
- enclosure made of grey PVC
- swivel acrylic glass lid with damping cylinder
- safety limit switch, automatic contact break
Zubehör
- connection units for our safety testers
